- Joined
- Jul 20, 2014
- Messages
- 1,386
I have a smallish collection of milling table clamps and fixtures but would like to expand.
Jergens, TeCo and Mitee Bite are a few that look well made and useful, but will probably go
with a Te Co set and a few Jergens. What is everyone here using and what do you like and would
like to buy? Some of these clamps/fixtures can get very expensive. What's good?
Also, how do some of you clamp small work that needs to get cut right to the bottom, say something like
a set of Jacobs wedges? Do you put a piece of sacrificial material on the bottom? wood, aluminum?
Jergens, TeCo and Mitee Bite are a few that look well made and useful, but will probably go
with a Te Co set and a few Jergens. What is everyone here using and what do you like and would
like to buy? Some of these clamps/fixtures can get very expensive. What's good?
Also, how do some of you clamp small work that needs to get cut right to the bottom, say something like
a set of Jacobs wedges? Do you put a piece of sacrificial material on the bottom? wood, aluminum?