- Joined
- Sep 24, 2016
- Messages
- 24
Ignore the following, but I can't igure out how to delete it. I hadn't noticed the relief in the drawing or the whole 2nd page of the thread.
Could you machine the larger pulley into the part and face it off. Then make the smaller pulley from a piece of plate. It looks like there should be enough metal to bolt the smaller pulley to the larger one. The through shaft should ensure centering when you drill the holes. Drill, tap and bolt the 1st hole before drilling the rest. Red LockTite between the mating faces.
Could you machine the larger pulley into the part and face it off. Then make the smaller pulley from a piece of plate. It looks like there should be enough metal to bolt the smaller pulley to the larger one. The through shaft should ensure centering when you drill the holes. Drill, tap and bolt the 1st hole before drilling the rest. Red LockTite between the mating faces.
Last edited: