- Joined
- Oct 21, 2014
- Messages
- 2,156
OK, have a functioning newer model MC60 controller, with a 2.6hp motor setup. Have it where I have momentary switch with relay to start it, a momentary switch to shut it down etc. All on the AC side of the setup.
Problem is when I shut it down and bring it back up. I then have to take the speed control all the way to 0 and then bring it backup.
This is on a bandsaw and I do not want to have to keep adjusting the speed each time unless I am changing the metal or something.
Does anyone know what resistor etc would need to be cut in order to prevent this problem. I can supply pictures etc if needed.
Problem is when I shut it down and bring it back up. I then have to take the speed control all the way to 0 and then bring it backup.
This is on a bandsaw and I do not want to have to keep adjusting the speed each time unless I am changing the metal or something.
Does anyone know what resistor etc would need to be cut in order to prevent this problem. I can supply pictures etc if needed.