- Joined
- Jun 7, 2013
- Messages
- 10,146
I have two #2 MT centers for my small lathe, one is hard, one is not hard, neither one is marked with the ring.
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Making a dead center
- Thread starter Abody711
- Start date
- Joined
- Sep 24, 2020
- Messages
- 1,922
Volume 1, Edition 43,copyright 1944.
I trust the twins more than most folks, especially lately.
Whatever is handy will work.
Softer is better as it will allow the work to grab it a bit.
Tailstock end needs to be live with a bearing or very hard with Grease.
Does not need to be marked, just toss it in when needed and give it a skim cut and it will be perfect every time.
Sent from my SM-G781V using Tapatalk
Softer is better as it will allow the work to grab it a bit.
Tailstock end needs to be live with a bearing or very hard with Grease.
Does not need to be marked, just toss it in when needed and give it a skim cut and it will be perfect every time.
Sent from my SM-G781V using Tapatalk