- Joined
- Feb 1, 2015
- Messages
- 9,640
Thanks for the insight @JimDawson . In the past I have not tried to use G10 to set the work offsets. I just moved to the new work origin and zeroed my coordinates.
I tried them in PathPIlot this morning and the G10 L2 P2 X~ Y~Z~ command does set the the offsets from the machine coordinates to the X~ Y~ Z~ values in the work offset table. Another tool in the arsenal. I haven't done any conditional programming in PathPIlot yet. Most of the programs that I run are through the CAM processor so there hasn't been a need.
I tried them in PathPIlot this morning and the G10 L2 P2 X~ Y~Z~ command does set the the offsets from the machine coordinates to the X~ Y~ Z~ values in the work offset table. Another tool in the arsenal. I haven't done any conditional programming in PathPIlot yet. Most of the programs that I run are through the CAM processor so there hasn't been a need.