- Joined
- Nov 27, 2012
- Messages
- 7,857
By the way, where did you find this information? Have a link? I would like to read up on it a little.
When I started out I was so confused on insert designations. Most tool supply catalogs will have a section that deciphers it all. I studied my Enco & MSC catalogs until I got a better understanding.
Once you get a bit familiar with it all you'll see a pattern & start to understand it easily.
Carbide Depot has a good resource online.
http://www.carbidedepot.com/resources.htm
This chart shows all the codes.
http://www.carbidedepot.com/formulas-insert-d.htm