Let's do it with a lathe, Part 2

[Norppu]

This video is rather long. This is to slow down the presentation/subtitle speed. I have also paid special attention to remove non-informational details from the subtitles. This all should slow down the tempo and give more time to read and digest the content.

Warning: The video has a long raptor-karaoke at the beginning. To skip it, just use the sections provided in the video.

In this second part of the series it is all about single point turning metric threads in the lathe.
Not just making the threads but how to make them accurately.
Some light is cast over all aspects of single point threading.

In this video I use Weiler Matador SV (1972) Lathe

The video is spoken in Finnish but it has good quality hand written subtitles in English and German.

 

[mrmax1984]

Terveisiä Floridasta! Jännä katella näitä metallihomma videoita Suomen kielellä kun olen jo muutaman vuoden verran katsollut niitä Englanniksi.

Tilaan? (subscribe?) sun kanavaan että tää kielitaito pysyy ehjänä. :-D