KO Lee arbor size

[Awleaphart]

Hello everyone.
First post here on the site.
I’m wondering if anyone knows the angle or taper type of the arbors that goes in the spindle of a KO Lee.
Thanks A Leaphart

 

[benmychree]

Hello everyone.
First post here on the site.
I’m wondering if anyone knows the angle or taper type of the arbors that goes in the spindle of a KO Lee.
Thanks A Leaphart

Having had one, I think it is unlike anything else.

 

[Awleaphart]

I am getting 1 degree 10 mins and 1 sec.
I hope that’s right. I got to make one.

 

[buffdan]

These were provided to me by Ken Stokley.
I think its a short B&S 5 which would be: 1° 11′ 50.28″

 

[Awleaphart]

Thanks a lot. That’s it. I made one at 1 degree and 10 mins. It was just a shim loose. There seams to be way more threads than need so I took some off the end to tightened it up. Got about .0005 run out one way and . 0008 the other. I also painted it because I made it out of cold rolled steel. Maybe that helped. Seams to be working great. But thanks again for the info.
A Leaphart