- Joined
- Jun 29, 2016
- Messages
- 16
Hi
I am using a Hitachi WJ200-015SF as a phase converter to run a Rockwell 14x30 lathe.
I have the out put of the VFD set to 60Hz and am using the speed control that is built into the lathe. When I slow the lathe down from the upper speeds I get an E07.3 error code. Over voltage protection on the DC bus voltage. Is there any way to stop this from happening?
Thanks
Tim
I am using a Hitachi WJ200-015SF as a phase converter to run a Rockwell 14x30 lathe.
I have the out put of the VFD set to 60Hz and am using the speed control that is built into the lathe. When I slow the lathe down from the upper speeds I get an E07.3 error code. Over voltage protection on the DC bus voltage. Is there any way to stop this from happening?
Thanks
Tim