I recently bought this lathe and owner had said it ran in forward, but not reverse. 220v single phase. It doesn't run at all. I've traced out wiring, switches, ect and everything looks intact.
Get voltage at correct places, except contacts do not pull. Manually depressing them, i still do not see voltage. 24v circuit and transformer seems fine.
Looking on the motor side, the diagram and most info is gone, scraped off. I believe it is a single phase motor though as i can see part of diagram and wires only run to 2 lines. I have 4 wires running in. U1, U2, V1, and V2. V2 is not connected. Everything looks unmolested and pretty on. Is it simply bad contactor coils or bad capacitor? The info i've found on comparable lathes, G9249, ect., does not match my electrical config.
My lathe has 2 contacts and others are showing three.
Any help,suggestions, ideas,or thoughts would be appreciated.
Get voltage at correct places, except contacts do not pull. Manually depressing them, i still do not see voltage. 24v circuit and transformer seems fine.
Looking on the motor side, the diagram and most info is gone, scraped off. I believe it is a single phase motor though as i can see part of diagram and wires only run to 2 lines. I have 4 wires running in. U1, U2, V1, and V2. V2 is not connected. Everything looks unmolested and pretty on. Is it simply bad contactor coils or bad capacitor? The info i've found on comparable lathes, G9249, ect., does not match my electrical config.
My lathe has 2 contacts and others are showing three.
Any help,suggestions, ideas,or thoughts would be appreciated.