- Joined
- Sep 24, 2020
- Messages
- 1,924
Has the accustep III installed.
When the table changes direction to feed out, the downfeed display shows the .0002 dialed in, the handwheel moves only .0001, when the Z changes to feed the table in, the display shows the .0002 down feed, but the handwheel drops .0003.
Any ideas ?
When the table changes direction to feed out, the downfeed display shows the .0002 dialed in, the handwheel moves only .0001, when the Z changes to feed the table in, the display shows the .0002 down feed, but the handwheel drops .0003.
Any ideas ?
Last edited: