- Joined
- Feb 8, 2014
- Messages
- 11,144
I am working on a project and needed a couple of knurled knobs in a size that I couldn't buy. I didn't own a knurling tool, and hadn't really had a use for one. So find a cheap one that will get the job done. No problem, Grizzly is 2 days away by UPS ground, and they are cheap, $39.95 + 8 bucks shipping.
I set it up and started to use it..............The ^*&(**(&^ top wheel runs out about 0.020, the axle pin hole was drilled off center. I never really looked at the bottom roller. I got my parts done OK, so all is not lost. But I'm not happy. I'll just buy some new, quality knurls for it, and go on with life. I need a full set anyway.
The real problem is laser etched right there on the bottom of the holder. But it was cheap, and I knew better.
I set it up and started to use it..............The ^*&(**(&^ top wheel runs out about 0.020, the axle pin hole was drilled off center. I never really looked at the bottom roller. I got my parts done OK, so all is not lost. But I'm not happy. I'll just buy some new, quality knurls for it, and go on with life. I need a full set anyway.
The real problem is laser etched right there on the bottom of the holder. But it was cheap, and I knew better.