- Joined
- Nov 21, 2013
- Messages
- 90
Hi Everyone!
I've been trying to dial my GO755 in a bit, and have noticed my spindle wobbles .0025. I've pulled the quill and checked the spanner nut, which was completely fine/tight. The spindle rotates smoothly, and there is no slop in either the spindle nor the quill.
My question is.. how untrue are the Grizzly spindles typically? Does .0025 seem excessive?
I must add... When I say wobble, I mean visually appears to wobble due to being untrue while the machine is running. The untrueness is measured evenly with an indicator both inside the taper, and on the outside of the spindle.
Thanks ahead of time for any help!
-Kory
Sent from my SGH-T599N using Tapatalk
I've been trying to dial my GO755 in a bit, and have noticed my spindle wobbles .0025. I've pulled the quill and checked the spanner nut, which was completely fine/tight. The spindle rotates smoothly, and there is no slop in either the spindle nor the quill.
My question is.. how untrue are the Grizzly spindles typically? Does .0025 seem excessive?
I must add... When I say wobble, I mean visually appears to wobble due to being untrue while the machine is running. The untrueness is measured evenly with an indicator both inside the taper, and on the outside of the spindle.
Thanks ahead of time for any help!
-Kory
Sent from my SGH-T599N using Tapatalk