-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Glacern 2.5" Face Mill
- Thread starter wrmiller
- Start date
Why? Isn't it R8?If its any consolation my 2.5" Glacern doesn't fit the 935TV
- Joined
- Dec 18, 2013
- Messages
- 2,012
Guys see my new thread over on the PM forum I don't want to highjack Bills thread.
Bill back to Glacern face mill discussion, it looks like you purchased the one piece face mill with integral R8 shank? You mentioned it rocking on a surface plate. I looked at that one but that little voice in my head was telling me it would be a lot more difficult to manufacture that to a tight tolerance so I opted for their two piece design. I could check mine, I have been meaning to order a surface plate anyway I need one to dial in the Starrett spindle square.
Bill back to Glacern face mill discussion, it looks like you purchased the one piece face mill with integral R8 shank? You mentioned it rocking on a surface plate. I looked at that one but that little voice in my head was telling me it would be a lot more difficult to manufacture that to a tight tolerance so I opted for their two piece design. I could check mine, I have been meaning to order a surface plate anyway I need one to dial in the Starrett spindle square.
