- Joined
- May 22, 2019
- Messages
- 89
So I was making a cut with if I remember correctly a 1/2 end mill when all of a sudden bam,and the motor is just buzzing.
I turn it off and turn back on and just buzzing so I switch to reverse and forward and do that a few times before it unlocks and starts spinning.
Now,since I’ve had this thing,a g0791 lathe mill combo,the mill head has been loud and clanky,but everything I’ve read says they are loud,so I kept on going and not saying anything to grizzly about it.
Now it seems as though there is even more clanken going on but there is not one broke tooth on any gear,but there the backlash had always seemed excessive.
Have anyone had any problems with there gearhead mills?
There are no plastic gears in this thing.
I turn it off and turn back on and just buzzing so I switch to reverse and forward and do that a few times before it unlocks and starts spinning.
Now,since I’ve had this thing,a g0791 lathe mill combo,the mill head has been loud and clanky,but everything I’ve read says they are loud,so I kept on going and not saying anything to grizzly about it.
Now it seems as though there is even more clanken going on but there is not one broke tooth on any gear,but there the backlash had always seemed excessive.
Have anyone had any problems with there gearhead mills?
There are no plastic gears in this thing.