- Joined
- Oct 4, 2016
- Messages
- 7,025
I have had the table but never really took it out of the box other than to inspect it for damage. I am finding that the the hold down clamp kit recommended as an accessory is 1/2". I have that kit for my mill a G0755. No way no how is a 1/2" T nut going to fit, and the register lug for vertical use on the table will have to come off to be used, it's too wide for the table slots.
I will call Grizzly tomorrow, but would like to have some input from other users if possible. What should I be using as a clamp kit?
The table slot opening is .475. Thank you
I will call Grizzly tomorrow, but would like to have some input from other users if possible. What should I be using as a clamp kit?
The table slot opening is .475. Thank you