- Joined
- Aug 2, 2016
- Messages
- 43
My lathe cuts about .006 taper in 5 inch cut.....
Questions
How do you know/tell head stock is aligned to bed?
How to diagnosis whats causing taper? head stock, bed, carriage or tail-stock. ?
I was reading the post on test bar storage so i do understand some taper is al;ways going to be there but i feel this is to much, what is acceptable taper?
Questions
How do you know/tell head stock is aligned to bed?
How to diagnosis whats causing taper? head stock, bed, carriage or tail-stock. ?
I was reading the post on test bar storage so i do understand some taper is al;ways going to be there but i feel this is to much, what is acceptable taper?