- Joined
- Jul 18, 2017
- Messages
- 69
I purchased my first big mill to replace my Central Machinery mill/drill. Needs a little work but the ways are in great shape. Biggest defect is the quill spring broke years ago and the table has been hit quite a few times when the quill fell while running. So I'm hunting a replacement spring. We picked it up and brought to my shop using a tandem axle trailer and an aluminum take down gantry, sketchy work but nothing was damaged.
Attached to the knee is a mystery bar. Does anyone know what this piece is for? It's on the left side just under the table and protruding out over the knee crank.
Also, if there is anyone who has a model like this, I need a picture of the spindle side variable speed pulley from the top. Where the arm that raises and lowers the front sheave attaches around the upper bearing, I have a pin in the front and back that don't look original and are loose. I wonder if they should be set screws.
Sent from my XT1254 using Tapatalk
Attached to the knee is a mystery bar. Does anyone know what this piece is for? It's on the left side just under the table and protruding out over the knee crank.
Also, if there is anyone who has a model like this, I need a picture of the spindle side variable speed pulley from the top. Where the arm that raises and lowers the front sheave attaches around the upper bearing, I have a pin in the front and back that don't look original and are loose. I wonder if they should be set screws.
Sent from my XT1254 using Tapatalk