Enco Tool post Question

[twhite]

I have this Enco 4 position Tool Post. As you can see it has 3 fixed a one for holder. I am thinking of using this on my 13” Clausing Colchester. The only problem is I only have the one holder. Searching for other holders to no avail. It looks like the 35 is an odd size.

I will verify if this will fit on my lathe once I fix the QCGB. If it does.

Does anybody have any laying about? Or know where I can get some?

I might have to make some. That would be a good project I guess.

Thanks


Cutting oil is my blood.

 

[T Bredehoft]

Given a mill, it would be relatively easy. You wouldn't have to concern yourself with fitting the fourth station, just set it up with a cut off tool or some standard chamfer, etc.

 

[twhite]

Given a mill, it would be relatively easy. You wouldn't have to concern yourself with fitting the fourth station, just set it up with a cut off tool or some standard chamfer, etc.

Yes I do have a mill. I have made a Norman type and a regular plunger tool posts and holders for my smaller lathes. So this would be straight forward. I then could make some custom ones also.

Cutting oil is my blood.