- Joined
- May 15, 2016
- Messages
- 98
I have a DRO mounted on my lathe Z axis. It is the cheap type from an EBay seller that you can cut to length. I can zero it just fine but the remote display skips in .200" increments in an unpredictable manner.
This is as you would expect very annoying and impossible to use. Barring buying a new DRO is there anything to do about it? It has been suggested to me to insert some small capacitors it the sending unit. A friend of mine has sent me some to solder in place and I might try that for the first line of attack but I would like to also find out if others have had similar issues with this type of DRO.
Dick
This is as you would expect very annoying and impossible to use. Barring buying a new DRO is there anything to do about it? It has been suggested to me to insert some small capacitors it the sending unit. A friend of mine has sent me some to solder in place and I might try that for the first line of attack but I would like to also find out if others have had similar issues with this type of DRO.
Dick