DIY chip guard for the mill

[Aukai]

I was messing around with a galvanized sheet, I rolled it in a 5 gallon bucket, and put a car door protector on the bottom lip. I'll probably make a shorter one if the knee has to come up higher.

 

[woodchucker]

I tried something similar on my Clausing... Stuff got around it , wound up bouncing back at me... other issues... it's sitting on the side now.
let us know how it works for you.

 

[Aukai]

Yeah, I'm just hoping to keep stuff from flying toward the laundry room door, and getting in the house. We'll see

 

[pineyfolks]

I have a piece of rubber trunk liner attached to the dovetail on my ram. It stops a lot of stuff from going behind my mill. It's bolted to some scrap square tubing I had laying around. Maybe you could make a wider one for yours.