- Joined
- Nov 22, 2010
- Messages
- 371
my grizzly SX3 has a digital readout on the quill. i had to take the slide if the widget out to install led lighting around the quill.
I removed the bracket that fastens the stationary end and simply puled the slide down and out...when it came out there was a thin spring type metal that came out with the slide...it was not attached to anything and simply keeeps a side-load on the slide bar.
I cannot get the slide bar back in with the "spring bar" it goes in just fine without the spring par bu that is not correct.
OK What am I doing wrong ??? do I ned to remove the whole caliper assembly to get it back in then re-assemble everything ??
BTW the two sets of led form a circle with anout 96 leds "lighing my work" works good . looks "Real Cool" but could use a little more light
I am going to try boosting the low voltage to about 18 volts...may blow the lights out as they were sold for auto usage to light up crap on Hot-rods... they are just flexible strip full of led's
Any help on the DRO would be appreciated
Joe
I removed the bracket that fastens the stationary end and simply puled the slide down and out...when it came out there was a thin spring type metal that came out with the slide...it was not attached to anything and simply keeeps a side-load on the slide bar.
I cannot get the slide bar back in with the "spring bar" it goes in just fine without the spring par bu that is not correct.
OK What am I doing wrong ??? do I ned to remove the whole caliper assembly to get it back in then re-assemble everything ??
BTW the two sets of led form a circle with anout 96 leds "lighing my work" works good . looks "Real Cool" but could use a little more light
I am going to try boosting the low voltage to about 18 volts...may blow the lights out as they were sold for auto usage to light up crap on Hot-rods... they are just flexible strip full of led's
Any help on the DRO would be appreciated
Joe