- Joined
- Jul 20, 2012
- Messages
- 1,245
I am going to make a base for my QCTP and take out the compound until needed. Looking for more rigidity.
I have a piece of 4140 PH that is about 2X2X6. I just need it surface ground on 2 opposing sides so it sits straight on the lathe cross. It can end up less that 2 inches as I will adjust the tool heights as needed.
Can anyone do this for me and what price? Please PM me through this site. Anyone in West Michigan so I can drop it off. Mail is good too.
I have a piece of 4140 PH that is about 2X2X6. I just need it surface ground on 2 opposing sides so it sits straight on the lathe cross. It can end up less that 2 inches as I will adjust the tool heights as needed.
Can anyone do this for me and what price? Please PM me through this site. Anyone in West Michigan so I can drop it off. Mail is good too.