Actually, I was a field service engineer for 10 years on Conomatics and 8 more years as Service Manager. Then I had my own production shop using Cones for 22 years. I was just curious if anyone else here had ever run or worked on multis.
we had a job we ran on an 1-5/8 rb 8 that we used to cut parts off one side, until we decided we could be cutting them off of both sides. I doubt they cut the price on them any but ill bet profits went up. two parts each machine cycle had to boost the profit margin!
Our R8s were triple cut offs. They made spacers from thin wall tubing. They had an expander tool to increase the OD and ID. Cycle time was 11 seconds. 8000+ in an 8 hour shift.
these were a bushing made from 1" D shaped stock, it made the reel stand rattle and the floor shake. I don't remember the cycle time, I do know they were used in the hvac trades as a part of a control arm.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.