- Joined
- Nov 16, 2012
- Messages
- 5,596
Ouch, this is the first issue like this I've ever seen. With the unit unplugged, have you checked that all the screws are snug? Also, check all the twistlock connections to make sure they're tight.
Matt runs all the machines before shipping them but only does the break-in sequence which takes about 10-15 minutes (he also checks all the table dimensions and inspects the tram). I'll send him an email and ask him to contact you. Rest assured, this will get resolved.
I recall another member with a different brand mill who had a similar problem and I believe the issue was due to the centrifugal switch.
Ray
Matt runs all the machines before shipping them but only does the break-in sequence which takes about 10-15 minutes (he also checks all the table dimensions and inspects the tram). I'll send him an email and ask him to contact you. Rest assured, this will get resolved.
I recall another member with a different brand mill who had a similar problem and I believe the issue was due to the centrifugal switch.
Ray