- Joined
- May 24, 2012
- Messages
- 395
I've regrinded a HSS aluminium tool trying to improve chip control.
It worked very nice at the start than....starter to be not good.
Looked for some aluminium sticked in the tip but notning....
6160 at 600rpm diameters around 1/2"...
Feel that i'm close but missed something.
Se the tool in action and what I said...
https://flic.kr/p/Dgbp2L
The angle of the chip changes!?!?!
It worked very nice at the start than....starter to be not good.
Looked for some aluminium sticked in the tip but notning....
6160 at 600rpm diameters around 1/2"...
Feel that i'm close but missed something.
Se the tool in action and what I said...
https://flic.kr/p/Dgbp2L
The angle of the chip changes!?!?!