- Joined
- May 28, 2013
- Messages
- 202
Ready to put power to my band saw, but he motor looked to be covered in muck.
Pulled the motor and cleaned the outside, but I want to pop open the end bells and ensure the inside is not full of what was on the outside.
Is there anything I need to look out for?
Plan is to remove the pulley from one end and the air pump from the other end.
Remove end bell bolts and nudge the end bell from the motor housing.
And to watch out for the old crunchy motor wires...
Any advice on things to look for?
toolman_ar
Pulled the motor and cleaned the outside, but I want to pop open the end bells and ensure the inside is not full of what was on the outside.
Is there anything I need to look out for?
Plan is to remove the pulley from one end and the air pump from the other end.
Remove end bell bolts and nudge the end bell from the motor housing.
And to watch out for the old crunchy motor wires...
Any advice on things to look for?
toolman_ar