A lathe upgrade or just a silly idea?

Cost benefit ratio isn’t there. If it were, you would see the application on at least commercial machines where every little bit of accuracy and speed is critical to making profits. There may be some out there, but to date, I have not personally seen any.

I will also admit I only partially read the responses and OP. I often loose interest in big, long, rambling walls of text.

A long, detailed, technical conversation face to face? Sure, I’m all in. A big wall of text? Nope, my effed up PTSD brain goes numb and just checks out.

Carry on….
 
Last edited:
Back
Top