O
ome
Forum Guest
Register Today
Can i take my grizzly 1/2 inch tee bolt and take a thou off each side until it reaches .47"?
I can scratch it with a drywAll screw, but it says it is case hardened.
What type of endmill,hss or carbide and whT speed mill is 124-1970rpm
thanks for any info because the cheapest price was travers at 220. Plus shipping and msc at about 202.
compared to my 56 piece 1/2 teebolt and clamp set fir 44. At grizzly plus tax and shipping. It is a big increase in the price. What do you guts advise?
Thanks,
jon
I can scratch it with a drywAll screw, but it says it is case hardened.
What type of endmill,hss or carbide and whT speed mill is 124-1970rpm
thanks for any info because the cheapest price was travers at 220. Plus shipping and msc at about 202.
compared to my 56 piece 1/2 teebolt and clamp set fir 44. At grizzly plus tax and shipping. It is a big increase in the price. What do you guts advise?
Thanks,
jon