- Joined
- Dec 30, 2016
- Messages
- 51
Sweet! This one came with three holders. I'll definitely need a couple more.
Despite what the other guys are saying it's a rusty ol' piece of junk, just send to me, I'll take care of it and shipping too.Sweet! This one came with three holders. I'll definitely need a couple more.
Despite what the other guys are saying it's a rusty ol' piece of junk, just send to me, I'll take care of it and shipping too.
That is a super sweet tool post. Had a sharp intake of breathe when I came across the picture.
I believe that is a Royal collet closer. If so....Attached is a manual. Also attached is some info I had saved. It was created by Bob Nawa from (I believe) the Clausing Group on Yahoo (now GroupsIO ).
Also- just in case you are unsure- after removing the back part of the collet closer assembly - you will loosen the nut (clockwise) to remove the spindle nose piece. That will pop out the collet adapter, .
Oil level should be at the middle line or slightly above but not above the top of the site gauge. Too high will cause increase drag and foaming of the oil. The biggest issue with the Multifix is the cost of the toolpost and holders. Real holders go for hundreds of dollars each. There are clones which are significantly less.
http://www.createtool.com/list.asp?cid=33