- Joined
- Nov 29, 2015
- Messages
- 439
So I got big ole machine/milling vise...not made for use on a rotating base. (I might figure that out anyway.) Anyway, it's got a number of issues. One is that it has a bent acme screw I will get to that later. It's had a rough life and currently has a lot of drill holes in it. I've ordered 1 pound of these: http://www.ebay.com/itm/Hobart-H990...cast-Electrodes-No-Tax-Free-Ship/182380233853 My stick welding isn't too bad. Might be better than my MIG welding. But anyway, I've never welded cast iron before and I'm wondering if I will need to heat it up to cherry red before welding it? It might be near impossible to do that since there is so much mass... Or is that only if you are brazing/TIGing it?
Paul
Paul