B
Buffalo20
Forum Guest
Register Today
I mentioned this plate in the Franken-Drill thread and decided to show it also. Its a 1/2" plate with a series of 1/2"-13 tapped holes and (4) 5/8" slots. Using t-nuts and studs in the drill press (DP) table, going through the slots and the vise (8" Palmgren), using some of the threaded holes, the vise is bolted to the plate, using studs and flange nuts. this allow the plate to slide all over the DP table and the vise to slide all over the plate, allowing it to be locked down, securely, anywhere.
1 - vise in
2 - vise out
3 - the plate
1 - vise in
2 - vise out
3 - the plate
Last edited by a moderator: