QUOTE="JimDawson, post: 423308, member: 29628"]:+1: what Jim said[/QUOTE]
Hello there again, Mr Dawson
Thought that would be the correct way it is done. But the Diameter is proving a bit of a challenge to get or construct those two sharp-edged Rails You are talking about
However, could we not do that on the Lathe, say between two centres, for example ???
Do kindly let us know
TIA
aRM
Hello there again, Mr Dawson
Thought that would be the correct way it is done. But the Diameter is proving a bit of a challenge to get or construct those two sharp-edged Rails You are talking about
However, could we not do that on the Lathe, say between two centres, for example ???
Do kindly let us know
TIA
aRM