- Joined
- Mar 21, 2013
- Messages
- 4,066
I would keep the light, get a 50-100w 24vdc PWM power supply off ePay to run it. They run off 100-240 vac. The stock transformer would not work with the Vfd source logic which is vdc. Would use a decent quality linear tracking 2-4w pot, either carbon film or wire wound. Also check Mouser Electronics, I can check if I have a spare and send when I get back from traveling.
I basically bought everything listed on your schematic (lighted jog, 4k pot, etc.). Even bought a metal E-stop switch and the graduated plate for the pot. All from AutomationDirect. Got a shipping notice in about 3 hours. Not bad...
Also on the buy list is a 14x12x8 enclosure from the same company. Just waiting on payday. I'm going to make a new control plate for the front of the lathe as well as a different oiling plate for the Norton. I'm liking John's idea of mounting the VFD on the side of the stand, but will have to put plugs/connectors on the box for the high voltage and control circuits so I can disconnect and move this thing a little easier.