- Joined
- Jul 29, 2014
- Messages
- 10
So...
How did this saga end?
Incidentally, I'm hoping to see some pics of a Cincy factory stop.
A crude drawing, or pic showing a rule would be helpful so that I might approximate OEM.
Some day I plan to make some for my 1B (some day).
Daryl
MN
I apologize for dropping the ball on this.
Nobody came forward with the size of the exposed X-axis pin, so I found a photo of a manual-feed 1D on the net and did some crude divider work to come up with an exposed length of just over one inch. There was about an inch imbedded in the table casting when I pull out the hacked-off stub, so I cut a two inch length of W1, faced it off, and tapped one end 3/8-24 (in case I ever need to pull the pin out). Froze it overnight in the freezer, heated the table a bit, and tap-tap-tap the pin went right in.
Here is a shot of the finished product.
Thanks to all who helped me on this.
Jeff Rininger