Yellow Box around Y-Axis Button - v3-23-11?

[ChazzC]

Hi, Yuriy,

I hadn't been on my mill for a week or so, and when I woke up the tablet (Samsung Tab A) today I saw that TDRO had upgraded to v 3-23-11. Everything running well, but just noticed that the Y-Axis Button outline is green while the X- & Z- are white:

Other than the axis names, all three are setup with the same options.

On the Fire HD-8 on the lathe (still v 3-23-04), the X- & Z- are white.


I honestly can't remember if the buttons were this way before the update or not; is this something new, or am I just special?


Thanks,


Charlie

 

[ycroosh]

Hi, Yuriy,

I hadn't been on my mill for a week or so, and when I woke up the tablet (Samsung Tab A) today I saw that TDRO had upgraded to v 3-23-11. Everything running well, but just noticed that the Y-Axis Button outline is green while the X- & Z- are white:

View attachment 470402
Other than the axis names, all three are setup with the same options.

On the Fire HD-8 on the lathe (still v 3-23-04), the X- & Z- are white.


I honestly can't remember if the buttons were this way before the update or not; is this something new, or am I just special?


Thanks,


Charlie

Charlie,
You have near-zero warning active on that axis. Open the axis details, and turn off the button with a speaker icon.

Regards
Yuriy

 

[ChazzC]

Charlie,
You have near-zero warning active on that axis. Open the axis details, and turn off the button with a speaker icon.

Regards
Yuriy

Thanks: I guess my pudgy fingers were at it again.