Tool Makers Vice Drawing

Flightmap

Flightmap

Active User
H-M Supporter Gold Member
Joined
Oct 30, 2013
Messages
82
I was kindly provided with a tool makers vice drawing by one of the site members. I would like to refine my request by asking if anyone has a "double screw (a left hand thread inside right hand screw) tool makers vice drawing. I have googled my request and actually had very few hits on any mill vice drawing. Thought that this wouldn't be the case.

Ken
 
I have a "Double Screw" vise I made as an apprentice. I have to clean it up so I can measure each part for you if you wish?

"Billy G"
 
If it is not a problem, I would love a drawing/method for reproduction.

Ken
 
I will take it apart tomorrow to clean it up. I should be able to dimension it as well.

"Billy G"
 
I'm working on them, I didn't forget ya.

"Billy G"
 
Billy, that sounds like something that I would also be interested in. If it is not too much to ask. Please and thank you.


Paul
 
Good morning - Yes that sounds like something that I would like to get into.

Thanks,
Woodrow
 
I would love some plans for that. I dont know if we will have to make one but it would be nice to have one done before being asked. Then I get to pick the better one for my self. ahahaha
 
You must log in or register to reply here.
Back
Top