Thread about EMCO Lathe Bed Alignment

[Richard King 2]

I posted this in the Emco Forum. In case you missed it. It's about a lathe that needs rebuilding, but I got it working for the owner so he could use it to make his parts.

EMCO Maxicut Lathe Alignment

Last month I was asked by Tony Baker a Knife maker in Cleremore, Oklahoma to help him to get his machine to cut with-out a taper. I have been down working in Nowata OK for the last 2 weeks. Last Sunday I drove over to Tony's shop and fixed his machine. Along story short he had to remove the...

www.hobby-machinist.com