Table saw tested for shop-use - OK !

[ksor]

Here is an old project I tested today:

More details here and you can Google Translate to the right just under the menu line - choose whatever language you like in the combobox:

http://kelds.weebly.com/lille-bordsav.html

 

[hman]

That's a very nice looking saw! Congratulations!

... and no need to call yourself "dumkopf" - your English is very good, and everything you said was easy to understand.

I have two suggestions. First, try putting just a bit of some oil or lubricant on top of aluminum pieces you're going to saw. It will improve the cut and reduce heating. Secondly, you might want to use a push-on-release-off foot switch to control the motor. It will free up both your hands for keeping control of the workpiece, etc.

 

[chuckorlando]

Awesome work as always.

 

[ksor]

Awesome work as always.

Thx !

 

[ksor]

That's a very nice looking saw! Congratulations!

... and no need to call yourself "dumkopf" - your English is very good, and everything you said was easy to understand.

I have two suggestions. First, try putting just a bit of some oil or lubricant on top of aluminum pieces you're going to saw. It will improve the cut and reduce heating. Secondly, you might want to use a push-on-release-off foot switch to control the motor. It will free up both your hands for keeping control of the workpiece, etc.

That foot switch was a good idea - and the tip on oil on the alu too - thx !