stainless

fernballan

H-M Supporter - Gold Member
H-M Supporter Gold Member
Joined
Sep 24, 2017
Messages
550
Turn outside diameter. Facing. And turning conical inner diameter 700mm deep


DSCF0155.JPG

DSCF0156.JPG

DSCF0157.JPG
 
Fraught with danger/peril, without a spider inside and support from tailstock center.
 
Very light cut low rpm and extra fastenings in the chuck
Just as I said, regardless of a few extra strap clamps and light cuts; is it worth breaking something to not take normal precautions with ordinary shop practice?
 
Some like to hang out on the proverbial limb, I've been known to at times. Where there is life, there is danger
 
I'd be curious to see the final results. To lazy to set up a steady rest?
 
Back
Top