- Joined
- Jul 22, 2019
- Messages
- 19
Thought I would experiment with an emco compact 5 lathe - using the printer port. Not the normal Step/dir though - I am outputting PDM and reading the encoders back - all using the printer port.
Here is where I am at now. (winter is coming and I have been side tracked with real world things)
Tuning the pid loop within linuxcnc - getting about .0002" following error.
sam
Here is where I am at now. (winter is coming and I have been side tracked with real world things)
Tuning the pid loop within linuxcnc - getting about .0002" following error.
sam
