- Joined
- Oct 7, 2013
- Messages
- 305
Hey folks, I have a Porter Cable vertical milling head I intended to put on a Burke #4 horizontal mill (see the pinned post above), but I have since sold the mill. I intend to sell this milling head, so if anyone is looking for one, message me. It's been a long time since I have seen one available for sale, so it appears they are pretty rare. This one has the 2.25" diameter overarm shaft. It appears to be in good condition (could use cleaning), but I was never able to adapt it to my Burke#4 machine, so I haven't used it. Everything feels smooth in it, but I haven't measured tolerances. My research indicates it has a Brown & Sharp #7 taper in the tool holder. Photos can be seen in the above pinned thread "Just Bought a Burke #4". For some reason my photos aren't uploading properly.