Mill Power Feed Table Stops

[pdentrem]

We made some for our BP from scraps. The switch is mounted inbetween the two and stops the feed on contact with the stop blocks. We do not feed at super high speed without being at the control. Overrun can happen but so for it has not happened. YET!

 

[Pacer]

I've got a couple extra --

Had smoke escape from a power feed (fried circuit board) and replaced it leaving me with all the mounting stuff.

Pay the postage and I'll send them to you... PM me.

 

[Pacer]

Hmmm, dunno what thats about - I tried it and seemed to work...

Anyhow --- email
pace8@bellsouth dot net

Was thinking after I sent that -- hope I remember where I ratholed that stuff, I have already robbed a couple things off it, but know those stops were still there.

 

[Davo J]

Sounds like your fixed up, but you can see the standard ones and the extended ones I made in this post below. Nothing special to them and if the table travel 4 inches you have something wrong, like the gibs are totally loose. The normal over travel I got when experimenting with the new stops was around 1 1,1/2 over travel.
http://hobby-machinist.com/index.php?topic=3478.msg25064#msg25064

Dave