Looking for wiring diagram

[magural]

Anyone have a wiring diagram for this Lathe.
I am working on retrofitting a VFD to this.

 

[4ssss]

Just use the wires going into the starter, and add new wires to your power source plug

 

[Ulma Doctor]

the motor wires and incoming power will go directly to the vfd,
you don't use contactors with VFD's.
the control circuit will need modification or retrofit to operate the machine
i can help if you need guidance

 

[magural]

Used a GS2 on the high speed side. of the motor. Disconnected the low speed wires.

Works good.
GS2 series AC micro drive, 230 VAC, 1hp with 3-phase and 1-phase input, V/Hz mode, RS-232/RS-485, Modbus, 5kA SCCR.