Looking for info on setting up a taper turn guide

[Ozwelder]

Hi guys,
I see plenty written about taper turn attachments .I can't get my head completely around the operation of the unit.
I understand that the cross slide is mechanically connected to the taper guide, so far so good!

This would mean that the cross thread shaft will need to be disconnected. It seems a real pain in the bum to disconnect and remove.
Is there something blindingly obvious that i am overlooking?
Could some kind soul run me through what I should do and not do.

When the unit is built, it will be for a 12 x 36 chinese lathe.
Thanks for your time

Ozwelder

 

[jumps4]

hi
what lathe is this, looking up the parts diagram may help to determine the easiest method. but most of the time removing the cross slide handle and bearing support is all thats required. leaving the screw in place. it is pretty easy on my 9x20 hf
steve

 

[12bolts]

Grahame,
Have a look at this http://www.hobby-machinist.com/show...-AR-9-quot?highlight=taper+turning+attachment and http://www.hobby-machinist.com/album.php?albumid=50 and post up some info and pics of your lathe. We should be able to help a bit more with a bit more info on hand.

Cheers Phil