Little Fab Job I did

[Charley Davidson]

I built this frame for a top on a fire truck being used as a BBQ/Smoker

 

[David]

Looks good Charley. Is the pit already on the truck, cain't tell from the photo. Maybe a couple of briskets and cash for this project!

David

 

[jumps4]

looks like your bender is working pretty good charley nice job
steve

 

[November X-ray]

Where's the beef???

 

[Old Iron]

Looks good Charley, Someone will want you to build a frame for a covered wagon. I think I built about 4.

Paul

 

[bcall2043]

I built this frame for a top on a fire truck being used as a BBQ/Smoker

Looks good Charley.

You need to find out where Everett is going to have his rig set up and we can go by for a sandwich.

Benny

 

[OlCatBob]

Hey Charley,
Just want to compliment you on the bending job, looks to be very consistent. I haven't seen that rig around town, but what a great idea!
Hope you are doing well, haven't seen either you or Benny in a few days; did run into Philco yesterday, good to see him as always.
Did you find the 211 welder yet?
Take care,
Bob

 

[Charley Davidson]

Did you find the 211 welder yet?
Take care,
Bob

No, I might have bought an old Miller 35 won't know till I get to work, sent a co-worker to look at it & pick it up if it's worth the $150.00 I offered for it.


Thanks guys

 

[Tony Wells]

I've got an old 35 S that I wouldn't take for. Pretty fair old machine for what it is. I got it for about that, if I recall. It's been a while. Needed to tighten the transformer output connections though, they were overheating.

 

[bcall2043]

No, I might have bought an old Miller 35 won't know till I get to work, sent a co-worker to look at it & pick it up if it's worth the $150.00 I offered for it.


Thanks guys

Looks like a good welder and in case it comes to live with you.

Link to the manual...
http://www.millerwelds.com/om/o1301q_mil.pdf

Benny