Link to “Shaper Work” – training document

[bcall2043]

In Ron’s (Scrapmetal) post I replied to Charley’s request for a digital copy of the file Ron had provided a link too. In that reply I mentioned another good shaper document and said I would provide a link to that file for the others.

Charley,
I put a copy on drive along with "Shaper Work - University of NY" which is a teaching aid for students. I will give them to you when Wayne and I come over to Murfreesboro.

Benny

Note added - I will try and find the link where I found the "Shaper Work" file and post it for the others. It is a large 57.1 MB file.

I could not find the link to the single file copy of Shaper Work training manual again. A copy broken into smaller chapter units can be found at the New England Model Engineering site. Their home page is at http://www.neme-s.org/index.htm. This a good site for shaper and other machining information.

The shaper training course developed for training the war time machinist can be found here http://www.neme-s.org/Shaper Books/Shaper Work/ .

Benny

 

[ScrapMetal]

Benny,

Thanks for that link. I'm downloading the chapters now.

-Ron