Just a little tool for the QCTP

[Rifleman1384]

I have the Dorian QCTP on my 1440GT but did not like the clock position on the lever. After a little digging around not being able to find a tool from Dorian or anyone else I made one so I could clock the lever to me liking. I used a 3d printed copy of the rose index to machine the hex on my mill (trying to decide on a dividing head, BS-0 or BS-1 and PM or Vertex) for the tool. The pin is stainless because that's what I had within reach. I blued the shaft just for the contrast effect and practice of the bluing process.

Steve

 

[woodchucker]

not sure how this is a lever, or what it really looks like, or how it will be used in your tool post.

 

[Rifleman1384]

It's to take apart the QCTP to re-clock the lever that hold the tool holders, make sense?

 

[woodchucker]

It's to take apart the QCTP to re-clock the lever that hold the tool holders, make sense?

ah, ok. those little pins fit where a spanner would go? ok, overkill, but ok.

 

[zjtr10]

Looks good And best of all you got to spend some time using our big boy toys.