INDEXER FOR ROUND COLUMN MILL

epanzella

epanzella

Active User
Registered
Joined
Apr 8, 2013
Messages
2,021
My old indexer of 6 years was in the way of a future project so I replaced it. While I was at it I upgraded to a 1.5 inch guide rod and ball bearings. The first pic is my old setup.
 

Attachments

  • DSC_0772.JPG
    DSC_0772.JPG
    290.6 KB · Views: 42
  • DSC_0775.JPG
    DSC_0775.JPG
    453.2 KB · Views: 38
  • DSC_0815.JPG
    DSC_0815.JPG
    594.2 KB · Views: 38
  • DSC_0874.JPG
    DSC_0874.JPG
    618.6 KB · Views: 39
  • DSC_0875.JPG
    DSC_0875.JPG
    559.6 KB · Views: 38
  • DSC_0877.JPG
    DSC_0877.JPG
    454.7 KB · Views: 42
Got my indexer dialed in this morning. I was dreading this but it only took 15 minutes. Maybe I AM learning stuff after all.
 

Attachments

  • INDEXER 2 DIALED IN.MOV
    31.3 MB
Looks good, I just completed something similar today.
www.hobby-machinist.com

Added linear bearings to round column mill - works

This is my attempt at fixing the round column registration problem. Part 1 was replacing the head lift crank with a windshield wiper motor from a saturn Vue (surplus at Princess Auto for $13) Action video...... https://www.dropbox.com/s/26wb19hzack3i44/VerticalLift Movie-short.wmv?dl=0 Part 2...
www.hobby-machinist.com www.hobby-machinist.com
 
You must log in or register to reply here.
Back
Top