For Some Reason

[MrWhoopee]

this really appeals to me.

William Nguyen on Reels | vanthefabricator · Original audio

1M views, 9.3K likes, 40 comments, 409 shares, Facebook Reels from William Nguyen. vanthefabricator · Original audio

www.facebook.com

 

[toprecyler]

As long as you remember not to hit the spindle switch.


Sent from my iPhone using Tapatalk

 

[wachuko]

I have to try that at some point!!

 

[Reddinr]

Cool. Could use a CNC conversion.

 

[GeneT45]

I have seen that done right, welding a cylinder, with an automatic weld positioner (auto rotab).

GsT

 

[OTmachine]

Might take out your DRO?

 

[MrWhoopee]

Might take out your DRO?

As long as the ground is directly attached to the part (in this case the aluminum tube parallel supporting the part) there should be no problem.

 

[Firstram]

As long as the ground is directly attached to the part (in this case the aluminum tube parallel supporting the part) there should be no problem.

This, I have welded quite a few driveshafts on a lathe. I use a 2' piece of stripped #2 welding wire that gets looped over the shaft for a ground. I use it whenever I'm welding aluminum and never get arc marks from the ground clamp.